Using the Tab key
By using the Tab key on the keyboard, it will actually automatically filled in the key for you
Connected to Dynamips VM "R1" (ID 0, type c3725) - Console port
Press ENTER to get the prompt.
Router>en
Password:
Router#sh
Router#show run
Router#show running-config
Connected to Dynamips VM "R1" (ID 0, type c3725) - Console port
Press ENTER to get the prompt.
Router>en
Password:
Router#sh
Router#show run
Router#show running-config
Using Cisco Synchronous Logging command to stop SYS-5-Config message keep popping up
Each time when a config is issue, the SYS-5-CONFIG_I will appeared and it keep appearing.
Router(config)#exit
Router#copy r
*Mar 1 00:11:54.039: %SYS-5-CONFIG_I: Configured from console by consoleun start Destination filename [startup-config]?
Building configuration...
[OK]
Router#Router(config)#exit
Router(config)#exit
Router#copy r
*Mar 1 00:11:54.039: %SYS-5-CONFIG_I: Configured from console by consoleun start Destination filename [startup-config]?
Building configuration...
[OK]
Router#Router(config)#exit